MARTIN-SENOUR CO -- 3094 VERY SLOW ACRYLIC LACQUER THINNER  -- 8010-00F030670
<pre>=====================  Product Identification  =====================

Product ID:3094 VERY SLOW ACRYLIC LACQUER THINNER
MSDS Date:04/01/1991
FSC:8010
NIIN:00F030670
=== Responsible Party ===
Company Name:MARTIN-SENOUR CO
Address:101 PROSPECT AVE N.W.
City:CLEVELAND
State:OH
ZIP:44115
Country:US
Info Phone Num:216-566-2902
Emergency Phone Num:216-566-2917
CAGE:MART2
=== Contractor Identification ===
Company Name:MARTIN-SENOUR CO
Address:101 PROSPECT AVE N.W.
City:CLEVELAND
State:OH
ZIP:44115
Country:US
Phone:216-566-2902
CAGE:MART2

=============  Composition/Information on Ingredients  =============

Ingred Name:PROPYLENEGLYCOL MONOMETHYL ETHER ACETATE,
    1-METHOXY-2-PROPANOL ACETATE
CAS:108-65-6
RTECS #:AI8925000
Fraction by Wt: 20%

Ingred Name:DIMETHYL SUCCINATE, DIMETHYL BUTANEDIOATE, BUTANEDIOIC
    ACID, DIMETHYL ESTER
CAS:106-65-0
RTECS #:WM7675000
Fraction by Wt: 1%
Other REC Limits:10 MG/CUM
ACGIH TLV:61 PPM

Ingred Name:DIMETHYL GLUTARATE	   *93-3*
CAS:1119-40-0
Fraction by Wt: 2%
ACGIH TLV:67 PPM

Ingred Name:WEIGHT PER GALLON IN POUNDS: 6.92
RTECS #:9999999WG

Ingred Name:VOL ORGANIC CMPD: 6.92 LBS/GAL
RTECS #:9999999VO

Ingred Name:ISOPARAFFINIC HYDROCARBONS (NAPHTHA PETROLEUM),
    HYDROTREATED HEAVY, NON AROMATIC HEAVY NAPHTHA) ISOPAR G *93-3*
CAS:64742-48-9
Fraction by Wt: 16%
OSHA PEL:300 PPM
ACGIH TLV:300 PPM

Ingred Name:TOLUENE
CAS:108-88-3
RTECS #:XS5250000
Fraction by Wt: 12%
Other REC Limits:375 MG/CUM
OSHA PEL:100 PPM
ACGIH TLV:100 PPM
EPA Rpt Qty:1000 LBS
DOT Rpt Qty:1000 LBS

Ingred Name:XYLENE, DIMETHYLBENZENE, XYLOL
CAS:1330-20-7
RTECS #:ZE2100000
Fraction by Wt: 6%
Other REC Limits:100 PPM
OSHA PEL:100 PPM
ACGIH TLV:100 PPM, SKIN
EPA Rpt Qty:1000 LBS
DOT Rpt Qty:1000 LBS

Ingred Name:METHANOL (METHYL ALCOHOL), COLUMBIAN SPIRITS
CAS:67-56-1
RTECS #:PC1400000
Fraction by Wt: 4%
Other REC Limits:200 PPM
OSHA PEL:260 MG/CUM
ACGIH TLV:262 MG/CUM (SKIN)
EPA Rpt Qty:5000 LBS
DOT Rpt Qty:5000 LBS

Ingred Name:ISOPROPANOL (ISOPROPYL ALCOHOL), 2-PROPANOL, DIMETHYL
    CARBINOL
CAS:67-63-0
RTECS #:NT8050000
Fraction by Wt: 15%
Other REC Limits:400 PPM
OSHA PEL:400 PPM
ACGIH TLV:400 PPM

Ingred Name:ISOBUTANOL/2-METHYL-1-PROPANOL/ISOBUTYL ALCOHOL
CAS:78-83-1
RTECS #:NP9625000
Fraction by Wt: 5%
Other REC Limits:50 PPM
OSHA PEL:300 MG/CUM
ACGIH TLV:152 MG/CUM
EPA Rpt Qty:5000 LBS
DOT Rpt Qty:5000 LBS

Ingred Name:ACETONE; DIMETHYL KETONE
CAS:67-64-1
RTECS #:AL3150000
Fraction by Wt: 19%
OSHA PEL:2400 MG/CUM
ACGIH TLV:750 PPM
EPA Rpt Qty:5000 LBS
DOT Rpt Qty:5000 LBS

=====================  Hazards Identification  =====================

Routes of Entry: Inhalation:YES  Skin:YES  Ingestion:YES
Reports of Carcinogenicity:NTP:NO    IARC:NO	OSHA:NO
Health Hazards Acute and Chronic:SKIN: ABSORPTION & IRRITATION.
    INHALATION: IRRITATION, NERVOUS SYSTEM DEPRESSION, MAY BE FATAL.
    PROLONGEDEXPOSURE TO SOLVENTS MAY RESULT IN ADVERSE EFFECTS TO
    LIVER/URINARY/BLOOD-FORMING/CARDIOVASCULA R/REPRODUCTIVE SYSTEMS &
    MAY RESULT IN PERMANENT BRAIN/NERVOUS SYSTEM DAMAGE.
Explanation of Carcinogenicity:NONE
Effects of Overexposure:INHALATION: HEADACHE, DIZZINESS, NAUSA, LOSS OF
    COORDINATION, UNCONSCIOUSNESS & DEATH. EYES/SKIN: REDNESS, ITCHING,
    & BURNING SENSATION.

=======================  First Aid Measures  =======================

First Aid:INHALATION: REMOVE TO FRESH AIR. RESTORE BREATHING. KEEP WARM
    & QUIET. SKIN: WASH W/SOAP & WATER. REMOVE CONTAMINATED CLOTHING.
    EYES: FLUSH W/PLENTY OF WATER FOR 15 MINS. OBTAIN MEDICAL ATTENTION
    IN A LL CASES.

=====================  Fire Fighting Measures  =====================

Flash Point:<5 F
Lower Limits:0.7%
Upper Limits:6.7%
Extinguishing Media:CO2, DRY CHEMICAL, FOAM
Fire Fighting Procedures:WATER SPRAY MAY BE INEFFECTIVE, BUT MAY BE
    USED TO COOL CLOSED CONTAINERS. FOG NOZZLES ARE PREFERABLE. WEAR
    SELF-CONTAINED BREATHING APPARATUS.
Unusual Fire/Explosion Hazard:POSSIBLE AUTOIGNITION OR EXPLOSION DUE TO
    PRESSURE BUILD-UP WHEN EXPOSED TO EXTREME HEAT.

==================  Accidental Release Measures  ==================

Spill Release Procedures:REMOVE ALL IGNITION SOURCES. VENTILATE &
    REMOVE W/INERT ABSORBENT.

======================	Handling and Storage  ======================

Handling and Storage Precautions:KEEP CONTAINER CLOSED WHEN NOT IN USE.
    TRANSFER ONLY TO APPROVED CONTAINERS W/COMPLETE & APPROPRIATE
    LABELING. USE ONLY W/ADEQUATE VENTILATION.
Other Precautions:USE APPROVED BONDING & GROUNDING PROCEDURES. DON'T
    SMOKE. AVOID BREATHING VAPOR & SPRAY MIST. AVOID CONTACT W/SKIN &
    EYES. KEEP OUT OF REACH OF CHILDREN.

=============  Exposure Controls/Personal Protection  =============

Respiratory Protection:WEAR A PROPERLY FITTED ORGANIC VAPOR/PARTICULATE
    RESPIRATORY APPROVED BY NIOSH/MSHA
Ventilation:LOCAL EXHAUST PREFERABLE. GENERAL EXHAUST ACCEPTABLE
Protective Gloves:REQUIRED
Eye Protection:SAFETY GLASSES W/UNPERFORATED SIDESHIELD
Work Hygienic Practices:REMOVE/LAUNDER CONTAMINATED CLOTHING BEFORE
    REUSE. WASH HANDS AFTER USING.
Supplemental Safety and Health
INTENTIONAL MISUSE BY DELIBERATELY CONCENTRATING & INHALING THE
    CONTENTS CAN BE HARMFUL OR FATAL.  WASTE DISPOSAL: DO NOT
    INCINERATE CONTAINER. DISPOSE OF IN ACCORDANCE W/FEDERAL, STATE, &
    LOCAL REGUL ATIONS REGARDING POLLUTION.

==================  Physical/Chemical Properties  ==================

Boiling Pt:B.P. Text:104-392F
Vapor Density:>1
Spec Gravity:0.79-1.06
Evaporation Rate &amp; Reference:SLOWER THAN ETHER
Percent Volatiles by Volume:100

=================  Stability and Reactivity Data  =================

Stability Indicator/Materials to Avoid:YES
ALUMINUM PARTS COULD CHEMICALLY REACT W/SOLVENTS IN THIS PRODUCT
    CAUSING A VIOLENT EXPLOSION.
Stability Condition to Avoid:IGNITION SOURCES
Hazardous Decomposition Products:CO2 & CO

====================  Disposal Considerations  ====================

Waste Disposal Methods:WASTE FROM PRODUCT MAY BE HAZARDOUS AS DEFINED
    UNDER RCRA. WASTE MUST BE TESTED FOR IGNITABILITY TO DETERMINE EPA
    WASTE NUMBERS. WASTE FROM MEK CONTAINING REDUCERS MUST ALSO BE
    TESTED FOR EXTRACTABILI TY. INCINERATE IN APPROVED FACILITY. (SEE
    SUPP)

 Disclaimer (provided with this information by the compiling agencies):
 This information is formulated for use by elements of the Department
 of Defense.  The United States of America in no manner whatsoever,
 expressly or implied, warrants this information to be accurate and
 disclaims all liability for its use.  Any person utilizing this
 document should seek competent professional advice to verify and
 assume responsibility for the suitability of this information to their
 particular situation.